Wood Split-Rail Fence Repair: Replace a Damaged Rail. The rails on a split-rail fence fit into holes in the posts. When a ...

When attached to the post, the 2-by-4 wooden cross rails will be sturdy enough to hold the fence in place. The brackets and bolts should be oriented perpendicular to the fence to maintain the best ...

The new post should be the same size as the rotten post, with a pressure-treated, ground contact wood used. Make sure the new post rises above the top of the fence; it can be cut to size later.

Treated wooden posts, either round or Square, at least 5 inches in diameter; Rails: 1-inch-by-6-inch-by-16-foot boards; ... For a fence with three rails, cut one rail in two and use one of the halves ...

Drive stakes into the ground a few feet past each corner or end post, and connect them with mason's string tied 12 inches above grade. We wanted the fence to run parallel to the sides of the house ...

Rough-cut the horizontal rails so they’re a tiny bit longer than the distance between the inner faces of the gate hinge posts at the level of top and bottom fence rails. Cuts are square and plumb.

If you plan to build a 6-foot-tall fence, then I’d sink the fence posts into the ground no less than 30 inches. The fence posts themselves should be at least 4-by-4-inch timbers. It might be a ...

Glidden and Elwood’s barbed wire fencing replaced the tried and true Virginia Rail fences, but the wire still required wooden fence posts, a LOT of wooden fence posts.

For the purposes of this story, call it a snake-rail fence, something that Robbie Cochran is building by himself along the road side of the Old Stone House, which will be 250 years old in 2016.

This wood fence post was created using several simple saws and some patience. (Tim Carter/Tribune Content Agency) By Tim Carter. PUBLISHED: March 8, 2025 at 5:45 AM EST.